The only downside of pneumatic tools is that sometimes the installer will get going a little bit too quickly and will lose track of where the nails are going.
Attaching hardie board siding.
You can make your own fiber cement starter strip by ripping a piece of hardieplank lap siding into 1 1 4 inch strips.
How to stagger lap siding for walls longer than 12 feet you ll need to butt additional lengths of siding together.
How to install hardie board lap siding preparation.
How to attach hardie board siding step 1.
James hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above.
Hardie plank siding is almost always installed with air nailers which are the best tool for quick installation.
From the ends of the plank.
Form a piece of plastic strapping into a loop on one end of the strap large enough for sliding the siding into.
Measure up from the ground 6 inches plus the width of one plank at a corner and make a.
Installing hardiplank lap siding.
After removal of the old siding new house wrap should be installed to provide a water barrier between the.
See below for a shopping list and tools subscribe to.
This old house general contractor tom silva shares his secrets for working with fiber cement siding.
Fasteners shall be installed between 1 in.
Install the starter strip for the hardie board siding.
The thin starter strip is installed level with the roof.