Place hanging hooks approximately every 2 feet along the length of gutter.
Attaching a gutter to siding.
Join the gutter to the corner with six rivets in the locations shown.
If you are able to access the studs.
Attaching gutter down spout to asbestos siding if you can use the old holes put some silicone in the holes and re use them by all means otherwise use a 3 4 zip in and don t strip it out you ll be juuuust fine.
Set out the gutter lines on the ground next to the area along the house where you will be installing them.
Drill holes for the expanding anchors every 16 inches or as specified by local codes insert the anchors hold the ledger in place and tap it with a hammer to indent the anchor locations on its back face.
They re fitted to the gutter hanger and then they are attached directly to the roof.
With help from an assistant hold the gutter in place.
Hold the downspout connector up against the bottom of the gutter and center it.
Insert 7 to 8 inch gutter screws into each hole where you removed one of the shorter gutter spikes.
Start by drilling a 1 8 in.
Ask this old house general contractor tom silva installs an alternative to a gutter when a traditional one does not work.
Inspect your gutters and look for an area where a downspout would not be obstructed on its way from the gutter to the ground near the roof.
A home without fascia needs to have gutters attached by roof straps.
Snap together the length of gutter as much as possible.
Anchor a ledger to a masonry wall with expanding anchor bolts begin by marking a line across the wall for the ledger s top edge.
Drill a hole wide enough to accept the anchor you will be used to attach the gutter clamp for the downspout.
How to fasten a downspout to vinyl siding.
Unlike standard gutter spikes which attach only to the fascia board behind the gutter gutter.
Fastening to masonry walls.
Now drill the remaining holes and install the rivets.
Rivets at the front of the gutter and installing the first rivet with the rivet gun.
How to attach downspouts to siding step 1.
The hardiplank is fastened to framing members such as studs.
These straps act as a sling for your gutter.
Locate your studs with a stud finder and fasten your gutters at those points with screws long enough to go through the siding and at.
Trace around the downspout.
Remove the clamp and drill the holes using the marker points as guides.
